Altronix FireSwitch108 Data Sheet Manual de usuario descargar pdf

Input:

• Powerinput:120VAC60Hz,4.8amp.

• Two(2)ClassAortwo(2)ClassBFACPinputs.

• Two(2)configurableinputstriggerviaClassAor

 ClassBFACPsignalcircuits(polarityreversal)or

 drycontacts.

Output:

• 24VDCvoltageregulatedpower-limitedNACoutputs.

• Outputpower:

 10ampmax.totalalarmcurrent.

 7ampmax.stand-bywithoutbatteryback-up.

 1ampwithbatteryback-upincluding

 dedicatedAux.output.

 For Canadian applications Stand-by with

battery backup is limited to 0.45 amp.

• 2.5ampmaxcurrentperoutput.

• One(1)auxiliaryoutputratedat1amp

 (regulated,batterybackedup).

 0.45 amp for Canadian applications.

• AnyNACcanbeconfiguredasanAux.outputwithor

 withoutbatteryback-up(specialapplicationonly).

 WhensetasAux.output,theoutputisnotsupervised.

• Programmablesupervisedindicatingcircuitoutputs:

 Eight(8)ClassBorFour(4)ClassA,

 oranycombinationofClassAandClassBcircuits.

• Thermalandshortcircuitprotectionwithautoreset.

Battery Backup:

• Built-inchargerforsealedleadacidorgeltypebatteries.

• Automaticswitchovertostand-bybatterywhen

 ACfails.

• Zerovoltagedropwhenswitchingoverto

 batterybackup.

Supervision:

• ACfailsupervision(form“C”contacts).

• Batteryfail&presencesupervision(form“C”contacts).

• Lowpowershutdown.ShutsdownDCoutputterminals

 ifbatteryvoltagedropsbelow70-75%for24Vunits.

 Preventsdeepbatterydischarge.

Special Features:

• ProgrammableLCDdisplayinterface.

• Ethernetportinterfaceforremoteprogrammability

 andmonitoring.

• 2-wirehorn/strobeSyncmodeallowsaudible

 notificationappliances(horns)tobesilenced

 whilevisualnotificationappliances(strobes)

 continuetooperate.

• TemporalCode3,SteadyMode,InputtoOutput

 FollowerMode(maintainssynchronizationof

 notificationappliancescircuit).

• Compatiblewith12VDCor24VDCfirepanels.

• Outputloopsupervisiondirectedtoinput1orinput2.

• CommontroubleDryN.C.outputforreporting

 troubletoremoteFACP.

• Groundfaultdetection-Groundfaultmaximumtest

 impedance1,000ohm.

• GroundfaultDryN.O.outputtoreportgroundfault

 toremoteFACP.

Electrical:

• Operatingtemperature:0ºCto49ºCambient.

• BTU/Hr.:122.84BTU/Hr.

• SystemACinputVArequirement:576VA.

Visual Indicators:

• LCDdisplay-Indicatestroublesandconditionsof

 operation.TroubleConditionMemoryfacilitates

 quickidentificationofanintermittent/fault

 (shortcircuit,openorground)whichhaspreviously

 occurredononeormoresignalingcircuitoutputs.

 LCDdisplayswhichoutputthefaulthasoccurredon.

Mechanical:

• EnclosureDimensions(HxWxDapprox.):

 15.5”(393.7mm)x12”(304.8mm)x4.5”(114.3mm)

 - Accommodatesuptotwo(2)12VDC/12AHbatteries.

• Productweight(approx.):12.4lbs.(5.62kg).

• Shippingweight(approx.):13.7lbs.(6.21kg).

Specifications

TheAltronixFireSwitch108isacosteffectivemanagedNACPowerExtender.Itinterfaces

with 12 or 24VDC Fire Alarm Control Panels (FACP) to provide Notification Appliance

Circuitexpansionsupport,foradditionalhorns/strobestoallowADAcompliancy.Italsopro-

videsauxiliarypowertosupportsystemaccessories.Itdeliverselectronicallyregulatedand

filtered24VDCpowertoClassBorClassANACloopcircuits.Additionally,aseparate1amp

auxiliaryoutputfor4-wiresmokedetectorsisavailable.Alarmcurrentcanbedividedbetween

theeight(8)outputsforpoweringNACdevices.Outputsareratedat2.5ampmax.,andcan

beindependentlyprogrammedforSteady,TemporalCode3orStrobeSynchronization.All

outputsmaybeprogrammedforInputtoOutputFollowerMode

(outputwillfollowinput.i.e.MarchTimeInput,MarchTime

Output).Innon-alarmconditionindependentloopsupervision

forClassAand/orClassBFACPNACcircuitsisprovided.Intheeventofalooptrouble,theFACPwillbenotified

viathesteeredinput(input1orinput2).Inaddition,therearecommontroubleoutputterminals[NC,C,NO]which

areusedtoindicategeneralloop/systemtrouble.Two(2)FACPsignalingoutputscanbeemployedanddirectedto

controlsupervisionandpowerdeliverytoanycombinationoftheeight(8)outputs.ItprovidesaprogrammableLCD

displayinterface,plusanethernetportinterfaceforremoteprogrammabilityandmonitoring.

FireSwitch108

Managed NAC Power Extender

Rev.DSFireSwitch108_02082013

FireSwitch108

Overview

1 2

Indice de contenidos

Pagina 1 - Managed NAC Power Extender

Input:• Powerinput:120VAC60Hz,4.8amp.• Two(2)ClassAortwo(2)ClassBFACPinputs.• Two(2)configurableinputstriggerviaClassAor Cl

Pagina 2 - Agency Approvals

Altronix Corp. - 140 58th Street, Brooklyn, NY 11220 • 718-567-8181 • 888-258-7669 • altronix.comEnclosure Dimensions (H x W x D) (approximate):15.5”

Comentarios a estos manuales

Sin comentarios

Altronix FireSwitch108 Data Sheet Manual de usuario

Busca en linea o descarga Manual de usuario para Accesorios para eléctrica Altronix FireSwitch108 Data Sheet. Altronix FireSwitch108 Data Sheet User Manual Manual de usuario

Indice de contenidos

Comentarios a estos manuales

Relacionado con productos y manuales para Accesorios para eléctrica Altronix FireSwitch108 Data Sheet