Altronix AL602ULADA Guía de instalación descargar pdf (Pagina 8)

- 8 - AL602ULADA

Optional hookups:

1- BatteryandACmonitoring:ACorBatteryFailconditionwillcausethecommontroubleinput[C“FAULT”NC]to

 reportbacktotheFACPviainput1andinput2.Thecommontroubleinputmayalsobeusedforotheroptional 

 supervisorymonitoring.(see Power Board Parameter for use of AC Delay, pg. 6)

 ToreportACandBatteryTroubleconnectthebatteryandACFailrelayoutputshownin(Fig. 2a)tothe

 commontroubleinput.

2- Drycontactinput(C“DRY1”NC)(C“DRY2”NC)canbeusedtoalarmoutputfroman

 addressablemodule(theseinputsareunidirectionandcannotreportbacktotriggermodule).

 Connection to triggering devices must be made within 20ft of distance and using conduit for wiring.

3- Auxiliaryoutput(-AUX+)24VDCat1ampmax.

4- ACLocal[NC,NO,C]shouldconnecttothehostcontrolpanelforlocalannunciationof

 thetroublecondition.

 Note: Ifcommontroubleinput,terminalsmarked[C“FAULT”NC]arenotused,theseterminalsmustbe

 shorted(connectjumper)toremaininactive.Foroptionalhookups(Fig. 2b).

Maintenance:

Unitshouldbetestedatleastonceayearfortheproperoperationasfollows:

Output Voltage Test:UndernormalloadconditionstheDCoutputvoltageshouldbecheckedforpropervoltagelevel

(26.2-26.4VDC recommended range).

Battery Test:Undernormalloadconditionscheckthatthebatteryisfullycharged.Checkspecifiedvoltage

bothatthebatteryterminalandattheboardterminalsmarked[+BAT--]toensurethatthereisnobreakinthebattery

connectionwires.

Fuses:Checkinputfuseonthepowersupplyboard,replaceifnecessary.Inputfuseratingis5amp@250V.

Note:Maximumchargingcurrentis650mA.

Note:Expectedbatterylifeis5years;however,itisrecommendedchangingbatteriesin4yearsorlessifneeded.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Altronix AL602ULADA Guía de instalación Pagina 8