Altronix HubWay EXP UTP Power Injector Installation Instruc Manual de usuario descargar pdf (Pagina 8)

Altronix is not responsible for any typographical errors.

14058thStreet,Brooklyn,NewYork11220USA,718-567-8181,fax:718-567-9056

website:www.altronix.com,e-mail:[email protected],LifetimeWarranty,MadeinU.S.A.

IIHubWayEXPP     A18J

- 8 - HubWayEXP UTP Power Injector

MEMBER

Mounting Options:

Fig. 7

Wall Mount Installation

1-Installmountingbrackets(A)ontheleftandrightsideofrackchassis using

 four(4)flatheadscrews(B)(included)(Fig. 8a).

2- Place unit at desired location and secure with mounting screws

(not included) (Fig. 8b).

Caution: It is necessary to

 makesuremountingscrews

are securely fastened to a

beam when installing the

unit vertically.

Rack Mount Installation

1- Removeanddiscardfactoryinstalledscrewsfrombothsidesofrackchassis(Fig. 7a).

2-Installmountingbrackets(A)ontheleftandrightsideofrackchassis using the

 four(4)flatheadscrews(B)(included)(Fig. 7b).

3- PlaceunitintodesiredEIA19”rackpositionandsecurewithmountingscrews(not included) (Fig. 7c).

Fig. 9

Fig. 8

Shelf Installation

1- Position and affix rubber pads (C) (included) at each

corner on the bottom of the unit (Fig. 9).

2- Place unit in desired location.

Mounting Hardware (Included):

Fig. 8b

Fig. 8a

Fig. 7b

Fig. 7a

Fig. 7c

Top Top Top

Front

Left

Front

Left

FrontLeft

LeftSide

RubberPad

Two(2)mountingbrackets

Six(6)flatheadscrews

formountingbrackets.

Four(4)rubberpads.

Remove

Dotted lines indicate studs behind sheetrock.

1 2 3 4 5 6 7 8

Comentarios a estos manuales

Sin comentarios

Altronix HubWay EXP UTP Power Injector Installation Instruc Manual de usuario Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Accesorios para eléctrica Altronix HubWay EXP UTP Power Injector Installation Instruc